I have found my pictures that I took during the build of my Quadcopter frame. (I thought I deleted them by mistake)
Drilling mounting holes
Emco unimat3
Drilling motor mount
Big hole to clear axle and washers including circlip
measurement of arms
measurement motor to motor
All layers done
All layers done other side
All layers done other side closeup
All layers done other side view
Here we see that the threaded rods are a bit to long. I ran out of 6mm alloy tube so I could not finish 4 spacers – they are going to be 20mm (the ones in the picture are all 15mm)
20mm is needed to make room for the EDB.
The layers are 95*95mm
The arms are 10*10mm and 300mm long
The cc between mounting holes are 40mm
The threaded rods are M3
Holes to motors are drilled to suit 22-20L and the landing gear
[ad#Google Adsense]
