I started some work on the Bixler. 2 long screws holds the motor in place – simply undo both and gently pull out the long wires if they are stuck in glue under the motor mount. The 2826 fits if you remove minor parts of the foam. I made a small groove for the wires to come out on top – I think this also acts as a cooling duct so I made the cuts at about 45 degrees. Motor will be soldered as I don’t rely on bullet connectors. Next up is to make templates for the pod and internal shelf.
-
- Old and new
-
- Removed foam
-
- Before and after
-
- Mounted
-
- 2 Screws
-
- Clearance
-
- Wires goes on top
-
- 2826 2200kV
-
- ESC location
[ad#Google Adsense]
