I finished a ESC calibrator today – a 5 minute DIY job.
A servo cable is soldered to a Pertinax breadboard with rows. 1 row for each wire to the servo connector. I chose to solder strips of 6 pins so I can calibrate 6 ESC’s at the time. All covered up by shrink tube.
I am also a big fan of DYMO. They are very easy to use and it is sweeet to label up your wires, motors and motor directions. All adds up to the overall touch of your multirotor.
-
- ESC calibrator
-
- DYMO labelling strip
A picture says more than 1 post in the blog 
[ad#Google Adsense]
