Monthly Archive: May 2014

May 22

HoverShip LKTR250 Mashup

Parts have been arriving to the 250Quad I’m currently working on. It is a mahsup between Hovership MHQ and LKTR250 I cut out the frame from PCB’s stripped from Copper. Templates was cut and clued onto the sheet of fiberglass. I used a Hegner MultiCut2 to cut out the parts and then I painted the frame. …

Continue reading »

May 17

250 Frame finished

I finished the frame for my 250 today…A nice job I must say….Here it is temporarily assembled with misc hardware (that will be replaced with nylon m3 screws)     As you can see the design is foldable with theese arms. I must do some thinking about the colors…Here I used white perler beads as …

Continue reading »

May 09

250 Quad

I have started to build a 250Quad for faster funflying and bashing. It will be a mix between Hovership MHQ and LKTR250. Plates will be cut from stripped PCB-boards. 4 plates in total and rubber dampers will be used “QAV-style” Parts ordered are Motors, ESC’s and propellers. Parts not ordered are flightcontrollers as I have …

Continue reading »

May 09

Hubsan update

I successfully repaired the Hubsan with a new board. Tiny wires to solder for LED’s and motors abut even worse was the ribbon cable to attach the FPV-board. Everything was OK the 1st time and I assembled it and took it for a spin indoors. Now I await the replacements sent from banggood.com – time …

Continue reading »