Soon I will add my programming for the quadcopter, but this is much easier – it needs only 4channels (THRO, AILE, ELEV, RUDD) and optionally 5th and 6th channel for changing flightmodes or turning sensors on/off
I use the 3 position lever (Flaps) for this – very convenient.
All channels used must be set to 125% travel (full PPM)
Then I have a 2way lever for more configs.
Make sure you follow the guides for your specific software regarding setup.
I have no trims – you can apply trims on software if needed.
2 comments
Do you have a video on the process to activate and setup 6 position switching with the dx7s for a quad? Iny information would help a lot.
Regards
Al Bernier
Author
HI!
I’m afraid I cannot help you – I do no longer use my DX7
//UndCon