The work on Bixler is slow 🙂 Yesterday I soldered new wires to the ESC that allows me to route the connector down into the battery compartment. I have been thinking a lot about a pod that fits all gear and I actually ordered a pod from Diydrones that can house the ardupilot/oilpan electronics including …
Tag: Turnigy
May 05
450 v2 ESC mounted
Today I got a parcel from GiantCod A 4ch FRSKY receiver that is 8ch in PPM mode that I will use so I only need 1 wire between RX and MultiWii. And I got 4pcs Hobbywing Flyfun 18A that are supposed to be the same as Turnigy Plush 18A. They are also using the same …
Jul 27
Turnigy 9X mod completed
I finally finished my Turnigy 9X mods. I had to purchase new soldering tips for my soldering iron as the one I had was pretty worn out. With a new tip I could solder the required petite wires to the Atmega chipset and to the surface mount resistors. I also soldered the RS232->TTL adaptor I …
Jun 28
USB Programmer
Jun 16
Turnigy 9X mod
Today I picked up my parcel containing a Turnigy 9X, Frsky diy module, LED backlight and a telemetry Rx. A few hours later and the mod is completed. Now I wait for my USB programmer so I can flash the atmega with something better than stock firmware. I removed glue from rear side of Turnigy-badge …
May 28
Latest purchase
I ordered a few items from www.Hobbyking.com. Turnigy 9X 9Ch Transmitter w/ Module & 8ch Receiver (Mode 2) (v2 Firmware) Turnigy 9X LCD Backlight Kit – White (DIY) FrSky DHT 8ch DIY Telemetry Compatible Transmitter Module FrSky D8R 2.4Ghz 8CH Receiver with Telemetery My intentions are a radio with external patch antenna
Apr 01
Turnigy ESC Programming
I had to alter the programming on my ESC’s for the MultiWii Quadcopter (any MultiWii that is) As I had a bad crash outdoors(see previous post with movie) I found out the hard way that I really had to alter the ESC programming. I already knew this but hoped I really didn’t have to do …